Checking The Ide Hard Disk Drive Jumpers - Epson Progression User Manual

Checking the IDE Hard Disk Drive Jumpers

IDE (Integrated Drive Electronics) hard disk drives have
jumpers that must be set for the drive to work properly with
your computer. The jumpers tell the computer whether you are
using one hard disk drive or two. If you purchased your system
with a hard disk drive already installed, these jumpers have
been set for you. You may need to change the jumper settings if
you install or remove a hard disk drive.
Note
You do not need to set these jumpers if you are removing
your only hard disk drive.
Check the jumper settings if you are doing any of the following:
computer
See the documentation that came with your hard
the proper settings. If you install two hard disk drives in your
system, you must change the jumper settings on each drive to
indicate which drive is the master (primary) drive and which is
slave (secondary) drive.
the
A master drive is the drive
system that the computer loads into its memory each time you
turn it
on.
both the master and slave drive, but the operating system must
be contained on the master drive.
4-4 Installing and Removing Drives
You can run application programs and store data on
you'll install the operating
on which
for
disk drive