Troubleshooting - Strong SRT 43UD6593 Manual

9. TROUBLESHOOTING

Before calling a service technician, review following information for possible causes and solutions for
the problem you are experiencing. If the TV does not work properly after checking it, please contact
your local service line or STRONG dealer. Alternatively, you can send a support mail via our website
www.strong-eu.com.
Problem
No picture, no sound
No colour
The remote control does not work
No picture, normal sound
Normal picture, no sound
Unorderly ripples on the picture
Snowy dots, blocking and
interference
Ghost
Radio frequency interference
Playback of video is causing picture
freeze/macro blocks or similar
distortion, especially on HD content
Possible cause and solution
1. Check if the fuse or circuit breaker is working.
2. Plug another electrical device into the outlet to make sure it is
working or turned on.
3. The power plug is in bad contact with the outlet.
4. Check the signal source.
1. Change the colour system.
2. Adjust the saturation.
3. Try another channel. Black-white programme may be received.
1. Change the batteries.
2. The batteries are not installed correctly.
3. Main power is not connected.
1. Adjust the brightness and contrast.
2. Broadcasting failure may happen.
1. Press the volume up button to increase the volume.
2. The volume is set to mute, press MUTE to restore the sound.
3. Change the sound system.
4. Broadcasting failure may happen.
It is usually caused by local interference, such as cars, daylight lamps
and hair driers. Adjust the antenna to minimize the interference.
If the antenna is located in the fringe area of a television signal where
the signal is weak, the picture may be marred by dots, show blocking
or break-ups. When the signal is extremely weak, it may be necessary
to install a special antenna to improve the reception.
1. Adjust the position and orientation of the indoor/outdoor antenna.
2. Check the connection of the antenna.
3. Fine tune the channel.
4. Try another channel. Broadcasting failure may happen.
Ghosts are caused by the television signal following two paths. One
is the direct path, the other is re ected from tall buildings, hills, or
other objects. Changing the direction or position of the antenna may
improve the reception.
This interference produces moving ripples or diagonal streaks, and
in some case, loss of contrast in the picture. Find out and remove the
radio interference source.
Read/write speed of your USB device could be too low. Make sure to
use a USB storage device with su cient speed and space. Pen drives
(USB sticks) may not support su cient speed.
29