Specifications - Strong SRT 43UD6593 Manual

Problem
No signal or weak signal,
intermittent reception
Bad picture / blocking error during
heavy rain
If the TV turns o after plugging a
cable into any connector
NOTE: If the problem persists after these solutions, please contact your local support centre or send a
support mail via our website www.strong-eu.com.

10. SPECIFICATIONS

Audio
Audio Output:
Video
Channel coverage:
System:
Connectors
1x ANT IN
1x SAT IN
1x CI
3x HDMI
2x USB
1x LAN (RJ-45)
1x S/PDIF (optical)
1x AV IN 3,5 mm
1x HEADPHONES
a) Cables might have loosened; moisture might have entered into
cables or connectors, heavy rain at present or heavy storm at
present. Check the cable connections, LNB and other equipment
connected between the LNB and the receiver, or peak the dish.
Wait for rain/storm to subside. Ask a local satellite specialist for
advice.
b) The satellite dish is not pointing at the (correct) satellite(s). Adjust
the dish. Ask a local satellite specialist for advice.
c) Satellite dish is too small, trees or buildings in path. Change to a
larger dish or change position of dish.
d) Signal is too strong, dish is oversized. Connect a signal attenuator
to the LNB input. Ask a local satellite specialist for advice.
Heavy rain will attenuate satellite signals, below a certain level
blocking will occur.
Make sure your dish installation is up to standards to minimize rain
e ects. When in doubt, ask a local satellite specialist for advice.
Again, turn on the TV.
2 x 10 W
DVB-T2: 174 MHz-230 MHz; 470 MHz-860 MHz
DVB-C: 113-858 MHz
DVB-S2: 950 MHz-2150 MHz
DTV: DVB-T2, DVB-S2, DVB-C
ATV: PAL/SECAM (BG/DK/1)
AV: PAL, NTSC, SECAM
30
Possible cause and solution