Golden AlanteSPORT GP208 Owner's Manual page 17

V. DISASSEMBLY and BATTERY REPLACEMENT
Tools required: Two 10mm sockets, open end wrenches, or adjustable wrenches.
1. Use the screws, washers, and nuts provided to connect the positive (red booted)
connector of each cable to the positive (+) terminal of each battery.
2. Use the screws, washers, and nuts provided to connect the negative (black booted)
connector of each cable to the negative (-) terminal of each battery. See figures 13 and
14.
LOCK
WASHER
NUT
3. Place the batteries in the battery tray. Be certain to position the terminals on each
battery as shown in Figure 12 on page 16. Secure the batteries in place using the Velcro
straps.
4. Connect the connectors of each battery cable to the corresponding connector on the
main wire harness. See figure 12 on page 16.
5. Cover the battery terminals with the protective caps provided. See figure 14.
6. Install the battery cover.
7. To disassemble, please reverse the above process.
FLAT
BATTERY TERMINAL
WASHER
Figure 13
BLACK -
Figure 14
RING TERMINAL
FLAT WASHER
BATTERY
RED +
17
BOLT