Table of Contents
Advertisement
Assembly/installation
3.2 Installation location requirements
4. Use a suitable tool (open-end wrench SW 21) to install the flame arrestor with adapter on the
sample gas inlet and outlet in a wrench tight manner.
5. The screwed joints of the flame arrestor with a G1/4" pipe thread according to ISO 228 serve
as gas connections.
Choose a material for the gas supply and exhaust lines that is suitable for the sample gas.
Observe the information in the relevant operating instructions during installation.
3.2
Installation location requirements
Direct sunlight
Device damage.
The device can overheat or materials become brittle due to UV exposure.
• Protect the device from direct sunlight.
• Make sure that the maximum permissible ambient temperature is not exceeded. Refer to
Insufficient air circulation
Risk of fire.
The device may overheat or start burning in case of insufficient air circulation.
• Ensure sufficient air circulation in the room. Refer to the information in Technical
24
①
Sample gas inlet and outlet
②
Flame arrestor with adapter
③
Sample gas connection
CAUTION
the information in Technical specifications (Page 57).
WARNING
specifications (Page 57).
Compact Operating Instructions in accordance with EN 61010-1 and EN 60079-0
Compact Operating Instructions, 09/2018, A5E45779389002-01
Advertisement
Table of Contents
