Page 1
Preface Table of Contents Introduction Reyrolle 7SR5 Devices and Front Fascia Panels Hardware Device Modules Technical Data V02.21 Manual C53000-T7040-C013-1...
Preface Purpose of the Manual This manual describes the hardware of the Reyrolle 7SR5 device family and provides general information on the product structure, the modules, and technical data. Target Audience This manual is mainly intended for protection system engineers, commissioning engineers, persons entrusted with the setting, testing and maintenance of automation, selective protection and control equipment, and operational crew in electrical installations and power plants.
Page 4
The engineering guide describes the essential steps when engineering with Reydisp Manager 2. In addi- tion, the engineering guide shows you how to load a planned configuration to a Reyrolle 7SR5 device and update the functionality of the Reyrolle 7SR5 device.
Page 5
Qualified electrical engineering personnel in the sense of this document are people who can demonstrate technical qualifications as electrical technicians. These persons may commission, isolate, ground and label devices, systems and circuits according to the standards of safety engineering. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 6
Guideline 2002/96/EC for electrical and electronic devices Guideline for the Eurasian Market AC 2 kV insulation test of reset coil, trip coil, and output contacts 5 kV impulse voltage test (type test) in compliance with Class III Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 7
This product includes software developed by the OpenSSL Project for use in OpenSSL Toolkit (http:// www.openssl.org/). This product includes software written by Tim Hudson (tjh@cryptsoft.com). This product includes cryptographic software written by Eric Young (eay@cryptsoft.com). Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Reyrolle 5 (7SR5) devices are supplied in size 6 and size 12 cases. [sc_7SR5_size6_front angle, 1, --_--] Figure 1-1 Size 6 Device The devices can be panel mounted or fitted into standard 19 inch rack systems. Dimensions are shown in Figure 2-1 Figure 2-2. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 13
² The captive screws on the front of the device should be loosened before withdrawal. ² The rear retaining screw must be removed to allow withdrawal of the device from the case. ² Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 14
Introduction 1.1 Design and Hardware Characteristics [sc_7SR5_Size6_rear, 1, --_--] Figure 1-3 Size 6 Device Rear (Device with 2 x Optical LC Ethernet Ports) NOTE Connector arrangement may differ depending on MLFB. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 15
Introduction 1.1 Design and Hardware Characteristics [sc_7SR5 Fascia - Example Mimic Displays, 2, --_--] Figure 1-4 Example Mimic Display Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
All devices include the front fascia HMI, a processor module, CT module, and a power supply module. Addi- tional modules are added dependent on the device functionality. Processor Module Power‑Supply Module Binary Input/Binary Output Modules CT Module VT Module Arc Flash Detector Inputs/High Speed Binary Outputs (Module 'A') Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
The case earth stud should be solidly earthed to the panel earth. Terminal B28 (power supply unit) should be connected to the case earth stud. A minimum wire size of 2.5 mm is recommended. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Individual operate voltage levels selectable in soft- ware: • Range 1: 24 V/48 V/ 60 V • Range 2: 110 V/125 V • Range 3: 220 V/250 V 2 Standard binary outputs (BO) Make contacts Independent circuits/terminals Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
1 A/5 A user selectable rating 3 Binary inputs Individual operate voltage levels selectable in soft- ware: • Range 1: 24 V/48 V/ 60 V • Range 2: 110 V/125 V • Range 3: 220 V/250 V Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Range 1: DC 24 V/DC 48 V/DC 60 V • Range 2: DC 110 V/DC 125 V • Range 3: DC 220 V/DC 250 V 2 Standard binary outputs (BO) Make contacts Independent circuits/terminals Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Further technical data for the current and voltage transformers can be found in the Device Manual > Technical Data chapter. NOTE Further information on the measuring accuracy of the analog inputs can be found in the Device Manual > Technical Data chapter. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
For time-critical applications with low-active signals, consider the specified dropoff times. If necessary, provide for active discharge of the binary input (for example, a resistor in parallel to the binary input or using a change-over contact). Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 34
Numerical aperture Signal rate connection test 1 pulse per second Pulse duration connection test 11 μs All values in combination with sensors approved by Siemens. Numerical aperture (NA = sin θ [launch angle]) Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Breaking capacity DC inductive 30 W at L/R = 40 ms DC resistive 75 W AC resistive 1250 VA Mechanical/electrical endurance Loaded cycles ≥ 10000 Making cycles ≥ 1000 Breaking cycles ≥ 1000 Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
120 Ω screened twisted pair (STP) cable Recommended external 120 Ω, 0.5 W terminating resistor Last relay 120 Ω, 0.5 W Connectors Pin crimp [dw_connection2wire, 1, en_US] Figure 4-1 Connection – 2 Wire: OV (System Common) Not Connected Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 37
Corresponds to IEEE 802.3, 100Base‑TX Signal Signal Description ETH_TX_P Transmit data + ETH_TX_N Transmit data - ETH_RX_P Receive data + – – – – ETH_RX_N Receive Data - – – – – – Screen Shield potential Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 38
Corresponds to IEEE 802.3, 100Base-FX Laser class 1 as per EN 60825-1/-2 With the use of 62.5 μm/125 μm and 50 μm/125 μm optical fibres Numerical aperture (NA = sin θ (launch angle)) Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 40
CISPR 22 150 kHz to 30 MHz limit class A voltage lines Radiated emission CISPR 11 30 MHz to 1000 MHz limit class A CISPR 22 1 GHz to 6 GHz limit class A Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
X-plane – 3.5 mm displacement below crossover frequency (8 IEC 60255‑21‑3, to 9 Hz) 1 gn above. class 1 Y-plane – 1.5 mm displacement below crossover frequency (8 to 9 Hz) 0.5 gn above. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
• Removing or inserting the withdrawable element under live voltage is prohibited. Some components are electrostatically sensitive in the removed state, no special precautions are required when in normal service conditions. Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
AC Current (I Nominal or Rated (1 A/5 A) rated AC Voltage (V Nominal or Rated (40 to 160 V) rated Frequency (f Nominal or Rated (50 Hz/60 Hz) rated Ambient temperature (T 20 °C Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
This product is CE compliant to relevant EU directives: 2014/35/EU: ‘Low Voltage Directive’ for electrical equipment designed for use within certain voltage limits Council Directive 2014/30/EU: EMC Directive. 2015/863/EU: Restriction of Hazardous Substances Directive (RoHS3) Other Certification ISO 9001 Quality Management Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Radius = 50 mm (minimum bending radius) NOTE The length of the cable protection sleeve also to be included in calculations. Tightening Torques for Terminal Screws Fascia lever handles – captive screw 0.3 Nm Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
7SR5 Device type Rated voltages for the power supply Rated voltages for the binary inputs (all inputs) Nominal rated values for current and/or voltage transformer rated rated rated inputs Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...
Page 48
Electrical Hazard European CE marking Refer to device documentation Waste Electrical and Electronic Equipment Directive (WEEE) Guideline for the Eurasian Market USB port to connect to other devices e.g. laptop Electrostatic Sensitive Devices warning Reyrolle 7SR5, Hardware, Manual C53000-T7040-C013-1, Edition 05.2021...