Toshiba RAS-25S4KVDG-ND Service Manual page 130

No. Part name
Heat exchanger
12
(Evaporator)
TCJ sensor
3) Remove 3 fixing screws of evaporator at the left side
4) Remove 2 fixing screws of evaporator at the right side
5) Remove the pipe holder from the rear side of the main
6) Pull out the heat exchanger to upper side.
<To re-installation>
- Keep the back body horizontally and put the heat
exchanger to the back body.
- Make sure the heat exchanger can be assembled with
the back body and secure it tightly with screws.
Procedures
Remove follow the procedure item ③, ④ and ⑥.
Remove TC/TCJ sensor, earth line and cover drain
from the heat exchanger.
TC sensor
of heat exchanger.
of heat exchanger.
body.
Pipe holder
Earth line
Fixing screws
Fixing screws
2nd Unlock the hook 2 positions
1st Unlock the hook 2 positions
- 130 -
Remarks
Cover drain