Toshiba RAS-25S4KVDG-ND Service Manual page 129

No. Part name
1) Remove drain pan follow the procedure
Cross flow fan
11
2) Loosen the set screw of the cross flow fan.
3) Remove 2 fixing screws from the bearing base
Fixing screws
of bearing base
4) Lift the heat exchanger follow the figure.
<To re-installation>
1) to incorporate the fan motor and the motor into the
- Install the cross flow fan so that right end if the 1st joint
from the right of the cross flow fan is keep 5mm from
closed wall of the main unit.
Procedures
item ⑦ and ⑩.
Hexagon screw driver
and 3 fixing screws of evaporator, then remove it
from the main unit.
Pull out the left hand side unit the cross flow fan
released from the shalf of the fan motor and then pull
out the lower side of heat exchanger follow the figure.
position in the follow figure.
Fixing screws
of evaporator
- 129 -
Remarks
Cross ow fan Body back
5.0 mm
Set screw Fan motor