After Use; Maintenance Schedule; Lubricating The Machine - Nilfisk-Advance Advance Condor 56413000 Instructions For Use Manual

Table of Contents

Advertisement

Available languages

Available languages

A-18 / ENGLISH

AFTER USE

1
When fi nished scrubbing, press the Scrub Off Switch (E). This will automatically raise, retract and stop all the machine systems (brush, squeegee, vacuum,
solution and detergent (AXP models)). Then drive the machine to a service area for daily maintenance and review of other needed service up keep.
2
To empty the solution tank, remove the Solution Drain Hose (4) from it's storage clamp. Direct the hose to a designated "DISPOSAL SITE" and remove the
plug. Rinse the tank with clean water.
3
To empty the recovery tank, pull the Recovery Tank Drain Hose (19) from its storage area. Direct the hose to a designated "DISPOSAL SITE" and remove
the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled fl ow of waste water). The Recovery Tank Drain Hose can
be squeezed to regulate the fl ow. Rinse the recovery tank with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged.
4
Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.
5
Remove the squeegee, rinse it with warm water and re-install on mount.
6
Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by removing the skirt and tilting the hopper up and
away from housing, then pull out.
7
Check the maintenance schedule below and perform any required maintenance before storage

MAINTENANCE SCHEDULE

Check/Clean the vacuum motor foam fi lter(s)
Check Foot/ Parking Brake For Wear & Adjustment
Clean Solution Trough on Cylindrical System
* Have Advance check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes check every
500 hours or once a year.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.
8
Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
9
Turn the Master Key Switch (A) OFF (O) and remove the key.
LUBRICATING THE MACHINE – FIGURE 9
Once a month, pump a small amount of grease into each grease fi tting on the machine until grease seeps out around the bearings.
Grease fi tting locations (or apply grease to) (AA):
Squeegee Caster Wheel Axle and Pivot
Steering Wheel Shaft Universal joint
Steering Chain
Squeegee mount angle adjustment knob threads
Once a month, apply light machine oil to lubricate the (BB):
Squeegee tool end wheels
Recovery Tank release latch
Brake Pedal (parking brake) linkage
A-18 - FORM NO. 56041633 - Condor™
MAINTENANCE ITEM
Charge Batteries
Check/Clean Tanks & Hoses
Check/Clean/Rotate the Brushes/Pads
Check/Clean the Squeegee
Check/Clean Vacuum Shut-Off Float
Clean Hopper on Cylindrical System
Check Each Battery Cell(s) Water Level
Inspect Scrub Housing Skirts
Inspect and clean Solution Filter
Purge Detergent System (AXP only)
Side Broom Maintenance
Lubrication - Grease Fittings
* Check Carbon Brushes
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Yearly
X
revised 3/06

Advertisement

Table of Contents
loading

Table of Contents