Table of Contents
Advertisement
Update Firmware with Push Firmware Feature
When you update a Relevé Spot luminaire to a newer firmware version using a USB drive or add
a Relevé Spot luminaire that is running a newer firmware version, you can use the Push
Firmware feature to push the newer firmware version from that luminaire to all connected
Relevé Spot luminaires.
The firmware update process can take up to 10 minutes to complete depending on the size of
the firmware bundle and the number of boards that require updates.
You can only use the Push Firmware feature if all of the luminaires are using firmware version
1.1.0 or later. Use a USB drive to update individual luminaires that are running versions older
than version 1.1.0.
1. If necessary, follow the instructions in
page
to install the new firmware version on the host luminaire (the luminaire from which
you will initiate the firmware update to the remaining luminaires on the data run).
2. Disconnect the DMX control source from the host luminaire's DMX IN port.
3. In the UI on the host luminaire, navigate the Main Menu and select Update Firmware.
4. Select Push Firmware.
5. Select Yes to install the firmware version indicated in the UI. The firmware is sent to the
Relevé Spot luminaires to which host luminaire is connected. The LCD backlights on the
luminaires that are receiving the updates flash on and off slowly to indicate that they are
receiving the bundle. In addition, progress bars on the LCDs of the luminaires show the
progress of the update.
When the firmware bundle has been pushed to the receiving luminaires, the LCD on the
host luminaire shows COMPLETE and the progress bar indicates 100%. The LCDs on the
receiving luminaires indicate that the bundle is being saved, and then the firmware
update begins on those luminaires.
Note:
luminaires show "ERROR." Press < on the receiving luminaires to cancel the update, or
wait three minutes for the UI to automatically time out and return to the Main Menu.
To voluntarily cancel the firmware update, press < on the host luminaire.
Note:
firmware feedback.
6. When all of the Relevé Spot luminaires have been updated to the new firmware version,
reconnect the DMX control source to the host luminaire's DMX IN port.
Advanced
The Advanced menu is password protected, reserved for trained and qualified technicians.
Password Protected
Please Enter Access
Code below:
Contact ETC Technical Support for assistance with advanced features.
Menu System
If an error occurs during the update procedure, the LCDs on the receiving
You may hear audible tones during the update process. This is normal encoder
Update Firmware with USB Drive on the previous
35
Advertisement
Table of Contents
