Table of Contents
Advertisement
Safety Notices
Relevé Spot is a high-performance automated spot luminaire that is intended for professional
use only . Read the entire user manual before installing and operating this equipment.
READ AND FOLLOW THESE SAFETY WARNINGS BEFORE USE:
For indoor use only. The luminaire is IP20 rated for installation in dry locations only. When
•
selecting the installation location, ensure the luminaire will not be exposed to extreme
cold or heat outside of the operational range (see
dust.
Do not project the light beam onto combustible surfaces or materials. The minimum
•
distance you should maintain from the luminaire head to an illuminated surface is 2 m,
and the minimum distance from the luminaire head to any flammable materials
(decorations, etc.) is 0.1 m.
The luminaire can be yoked in any mounting position, but it must be mounted and
•
supported only by the suspension locations provided in the enclosure. See
Mounting Rails on page 19
The installation location must safely hold ten times the weight of the Relevé Spot
•
luminaire and support its intended operation. See
Suspend the luminaire from a suitable structure using a minimum of two hook clamps (not
•
provided) and secured with tightened steel bolts (12 mm (1/2 in) diameter), washers, and
locking nuts.
Always use and install a suitable safety cable as a secondary safety measure to prevent
•
accidental damage and/or injury in the event the installation clamps fail. The safety cable
must, at a minimum, hold ten times the weight of the luminaire. ETC offers a suitable
safety cable, which is available separately. Order part number 7060A1022.
Disconnect the luminaire from power and DMX and allow it to cool before performing any
•
cleaning and maintenance procedures.
Storage and Transporting
Use care when transporting or storing the Relevé Spot luminaire. Use a fitted road case or reuse
the original shipping materials to safely transport or store the luminaire.
Note:
transporting. See
Unpacking Instructions
The luminaire is fully calibrated and tested at ETC, then carefully packaged in a shipping carton
that includes the luminaire and two clamp mounting rails.
Visually inspect the shipping carton for damage that may have occurred during transit. If the
shipping carton shows signs of damage, document the damage fully before unpacking the
luminaire. Documentation of any damage is helpful when reporting a claim with the carrier.
The luminaire weighs approximately 67 lbs. (30.4 kg). For your safety, ETC recommends that
two people unpack the luminaire from the shipping carton. Use the provided handles on the
yoke arms and the enclosure to lift the luminaire from the shipping carton.
The shipping carton and packaging materials can be valuable if you ever need to ship the
fixture, including transporting the fixture for service. Do not discard. If you do not require this
packaging for future use, please recycle the materials through your local recycling program.
Introduction
.
All pan and tilt locks on the Relevé Spot should be released before
Pan and Tilt Locks on
Environment on page 12
Weight on page 13
page 8.
), moisture, or
Attach Clamp
.
5
Advertisement
Table of Contents
