Texas Instruments MLTLDO2EVM-037 User Manual page 12

Introduction
2.5.60 TP21 – KVU3_OUTPUT_GND
A3-pin KVU output ground test point.
2.5.61 TP22 – KVU5_OUTPUT
A 5-pin KVU output test point.
2.5.62 TP23 – KVU5_INPUT
A 5-pin KVU input test point.
2.5.63 TP24 – KVU5_EN
A 5-pin KVU enable test point.
2.5.64 TP25 – KVU5_BODE_BOTTOM
A 5-pin KVU bottom bode resistor test point.
2.5.65 TP26 – KVU5_BODE_TOP
A 5-pin KVU top bode resistor test point.
2.5.66 TP27 – KVU5_FB
A 5-pin KVU feedback pin test point.
2.5.67 TP28 – KVU5_FB_GND
A 5-pin KVU ground test point.
2.5.68 TP29 – KVU5_INPUT_GND
A 5-pin KVU input ground test point.
2.5.69 TP30 – KVU5_OUTPUT_GND
A 5-pin KVU output ground test point.
2.6 Soldering Guidelines
To avoid damaging the integrated circuit (IC), use a hot-air system for any solder rework to modify the
EVM for the purpose of repair or other application rework. An IR infrared rework station may also be used
to rework the EVM.
2.7 Equipment Connection
Connect the equipment as shown in the following steps:
1. Review the data sheet for the linear regulator being installed on the MLTLDO2EVM-037 EVM.
2. Set the input power supply up to maximum rated voltage as listed on the data sheet, then turn it off.
3. Locate the positive banana connector (if the input voltage will be less than or equal to 50 Vdc) or the
screw terminal (if the input voltage will be greater than 50 Vdc) on the EVM for the linear regulator
package you are testing. Connect the positive terminal of the input power supply to the correct positive
input on the EVM.
4. Locate the ground banana connector (if the input voltage will be less than or equal to 50 Vdc) or the
screw terminal (if the input voltage will be greater than 50 Vdc) on the EVM for the linear regulator
package you are testing. Connect the ground terminal of the input power supply to the correct GND
input of the EVM.
5. Locate the output banana connectors (if the output voltage will be less than or equal to 50 Vdc) or the
12
MLTLDO2EVM-037 Evaluation Module
Copyright © 2020, Texas Instruments Incorporated
www.ti.com
SBVU065 – May 2020
Submit Documentation Feedback