Glan Enable/Disable; Watch Dog Enable/Disable; Power Fail Alarm Enable/Disable - Supero SUPERSERVER 6113L-8 User Manual

GLAN Enable/Disable

Change the setting of jumper J7 to
enable or disable the onboard GLAN
ports (GLAN1 and GLAN2) on the
serverboard. See the table on the
right for jumper settings. The default
setting is enabled

Watch Dog Enable/Disable

J31 controls Watch Dog, a system
monitor that takes action when a soft-
ware application freezes the system.
Jumping pins 1-2 will have WD reset
the system if a program freezes.
Jumping pins 2-3 will generate a non-
maskable interrupt for the program
that has frozen (requires software
implementation).
also be enabled in BIOS.
Power Fail Alarm Enable/
Disable
The system will notify you in the
event of a power supply failure. This
feature assumes that redundant
Supermicro power supply units are
installed in the chassis. If you only
have a single power supply installed,
you should disable this (the default
setting) with CN5 to prevent false
alarms. See the table on the right for
jumper settings.
Watch Dog must
5-23
Chapter 5: Advanced Serverboard Setup
Enable/Disable
Jumper Settings
Jumper
Position
Pins 1-2
Pins 2-3
Watch Dog
Jumper Settings (J31)
Jumper
Position
Pins 1-2
Pins 2-3
Open
Alarm Reset
Jumper Settings
Jumper
Position
Open
Closed
GLAN
(J7)
Definition
Enabled
Disabled
Definition
WD to Reset
WD to NMI
Disabled
(CN5)
Definition
Enabled
Disabled