Connection; Structure And Parts; First Commissioning - saro GTK 370 Manual

CONNECTION

After prolonged transport, the unit should not be put into operation until 24 hours have elapsed, also after
strong inclination; that the cooling circuit stabilises again, refrigerant distributes evenly again
in order not to cause a defect or malfunction.
After short movement and inclination below 45 degrees, please wait 2 hours before connecting.
Before connecting the unit, make sure that the voltage and frequency of the power supply match the specifications on t h e type
plate! Other voltages can cause the unit to overheat!
Only connect the appliance to an earthed socket outlet with a 230 volt connection.
Once you have connected the appliance, wait about an hour to allow the interior to cool down sufficiently before loading it with
goods.
After a power failure or if the unit has been disconnected from the mains, wait at least 5 minutes before reconnecting the unit
and putting it into operation!
If the unit is restarted immediately after it has been switched off, the fuse may blow and interrupt the flow of electricity. In addition,
the compressor may be overloaded and damaged.
STRUCTURE AND PARTS (model example GTK 370)

FIRST COMMISSIONING

Before first use:
Unpack the unit, check it for completeness and set it up (see Setting up the unit). Clean the appliance (see Cleaning).
Connect the cleaned cooling unit (see unit connection) to a 230 V socket.
Only when the desired temperature has been reached do you place your goods in the appliance.
To save energy and prevent cold air from escaping, they always keep the door open only as long as necessary.
These models have a recirculation fan, which ensures that the cold air circulates inside. The gaps between the shelves and the
door help the air to circulate. When placing your goods in the cabinet, make sure that the air can circulate freely and that no
goods protrude or cover the ventilator. Distribute the goods evenly on the shelves.
Seite 23 von 30
09/23 SvN