Table of Contents
Advertisement
13.4 Cleaning the stainless steel surfaces
Observe the information regarding the cleaning
1.
agents.
Clean using a sponge cloth and hot soapy water in
2.
the direction of the finish.
14 Cleaning function
Use the cleaning function regularly to help retain the
cleaning ability of the self-cleaning surfaces and pre-
vent damage.
The self-cleaning surfaces in the cooking compartment
are coated with a porous, matte ceramic layer and
have a coarse surface. When the appliance is in opera-
tion, the self-cleaning surfaces absorb splashes of fat
from baking, roasting or grilling and break them down.
The following surfaces are self-cleaning:
¡ Back panel
¡ Door
¡ Side walls
ATTENTION!
If the self-cleaning surfaces are not cleaned regularly,
the surfaces may be damaged.
If dark spots can be seen on the self-cleaning sur-
▶
faces, use the cleaning function to clean the cook-
ing compartment.
If a request to clean appears, use the cleaning func-
▶
tion to clean the cooking compartment.
Do no use any oven cleaners or abrasive cleaning
▶
aids. If oven cleaner accidentally comes into contact
with the self-cleaning surfaces, dab the surfaces im-
mediately with water and a sponge cloth. Do not rub
them.
14.1 Cleaning recommendation
The appliance records the type and duration of the op-
eration and, if required, recommends which cleaning
function to use.
When lights up in the display while the appliance
▶
is switched off, use the cleaning function as soon as
possible.
To remove the note from the display, press any
‒
button except for the
ues to appear until the cleaning function has
been carried out in its entirety.
To reset the cleaning recommendation, press
‒
and hold the
button for approx. four seconds.
The note no longer appears until the appliance
has recorded the corresponding number of oper-
ations again.
Note: If the appliance is prematurely contaminated, e.g.
by greasy poultry or roasts, or if dark spots appear on
the self-cleaning surfaces, do not wait until the note ap-
pears in the display before you use the cleaning func-
tions. The more often the cleaning function is used, the
longer the cleaning ability of the self-cleaning surfaces
is retained.
button. The note contin-
Dry with a soft cloth.
3.
Apply a thin layer of the stainless steel cleaning
4.
product with a soft cloth.
Tip: You can obtain stainless steel cleaning products
from after-sales service or the online shop.
14.2 Preparing the appliance for the
cleaning function
Carefully prepare the appliance in order to achieve a
good cleaning result.
ATTENTION!
Using oven cleaner on the self-cleaning surfaces dam-
ages the surfaces.
Do not use oven cleaner on the self-cleaning sur-
▶
faces. If oven cleaner does get onto these surfaces,
dab it off immediately using water and a sponge
cloth. Do not rub the surface and do not use abras-
ive cleaning aids.
Remove accessories and cookware from the cook-
1.
ing compartment.
Detach the shelf supports and remove them from
2.
the cooking compartment.
→ "Rails", Page 22
Remove coarse dirt using soapy water and a soft
3.
cloth:
– From the cooking compartment floor
– From the inside of the appliance door
– From the glass cover on the oven light
This prevents stubborn stains.
The cooking compartment must be completely
4.
empty.
14.3 Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of burns!
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never touch the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Requirement: Prepare the appliance for the cleaning
function. → Page 21
Use the function selector to set the
1.
tion.
a The display shows the duration. The duration of
one hour cannot be changed.
Turn the rotary selector.
2.
a
appears in the display.
a After a few seconds, the cleaning function starts and
the duration counts down.
a When the cleaning function ends, a signal sounds
and the duration is at zero in the display.
Switch off the appliance.
3.
Wipe the appliance. → Page 22
4.
Cleaning function en
cleaning func-
21
Advertisement
Table of Contents
