M.2 Solid-State Drive; Removing The M.2 2230 Solid State Drive - Dell Inspiron 15 3535 Owner's Manual

Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module into the memory-module slot on the system board.
3. Press down on the memory module until the securing clips click, locking the memory module in place.
NOTE: Repeat steps 1 to 3 if there is a second memory module to be installed into your computer.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in

M.2 solid-state drive

Removing the M.2 2230 solid state drive

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid state drive installed.
NOTE: The M.2 card installed on your computer depends on the configuration ordered. Supported card configurations on
the M.2 card slot:
● M.2 2230 solid state drive
● M.2 2280 solid state drive
46 Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.