Table of Contents
Advertisement
5. Install the
display
assembly.
6. Install the
wireless
card.
7. Install the
base
cover.
8. Install the
SD
card.
9. Follow the procedure in
Camera assembly
Removing the camera module
CAUTION:
The information in this section is intended for authorized service technicians only.
NOTE:
This procedure is applicable for systems shipped with a plastic chassis only.
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
wireless
card.
5. Remove the
display
assembly.
6. Remove the
hinge
caps.
7. Remove the
display
bezel.
8. Remove the hinges.
9. Remove the
display
panel.
About this task
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Steps
1. Using the pull tab, disconnect the camera cable from the camera module.
2. Using a plastic scribe, pry the camera module from the display assembly.
NOTE:
Start prying the camera module in a sequential order 1>2>3 as indicated on the display back cover.
3. Lift the camera module from the display assembly.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
101
Advertisement
Table of Contents
