Steps
1. Disconnect the eDP cable from the camera.
2. Peel and remove the eDP cable from the display cover.
Installing the eDP cable
CAUTION:
The information in this section is intended for authorized service technicians only.
NOTE:
This procedure is applicable for systems shipped with a plastic chassis only.
About this task
The following image indicates the location of the eDP cable and provides a visual representation of the installation procedure.
Steps
1. Adhere the tape to securing the eDP cable to the display back cover.
2. Connect the eDP cable to the camera.
Next steps
1. Install the
display
panel.
2. Install the hinges.
3. Install the
display
bezel.
4. Install the
hinge
caps.
100
Removing and installing Field Replaceable Units (FRUs)