I/O Daughter Board Ffc; Removing The Input/Output Daughter Board Ffc - Dell Inspiron 15 3535 Owner's Manual

Steps
1. Place the heat sink on the system board.
2. Replace the three (M2x3) and tighten four captive screws that secure the heat sink to the system board.
NOTE: Replace and tighten the screws in the sequential order mentioned on the heat sink [1 > 2 > 3 > 4> 5 > 6 > 7].
NOTE: The number of screws varies depending on the configuration ordered.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in

I/O daughter board FFC

Removing the Input/Output daughter board FFC

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the fan.
About this task
The following image indicates the location of the Input/Output daughter board FFC and provides a visual representation of the
removal procedure in an aluminum chassis.
70 Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.