Cisco Nexus 9508 Hardware Installation Manual page 75

Replacing or Installing Modules, Fan Trays, and Power Supplies
3. Expand Chassis.
4. Expand Fabric Modules.
5. Choose the appropriate fabric slot.
c) On the upper right corner of the Properties screen, choose Actions > Disable.
d) Verify that the Fabric LED for the slot that you specified turns off.
Step 4
Remove the fabric module that you are replacing by following these steps:
a) Unscrew the screw on the center of each of the two handles on the fabric module. See Callout 1 in the following
figure.
1 Unscrew 2 captive screws (1 on each ejector handle).
b) Rotate the two handles at least 30 degrees so that the other end of each handle no longer holds the module in the slot.
See Callout 2 in the previous figure.
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of the slot. See
the following figure.
2 Rotate both ejector handles away from the front of
the fabric module.
Cisco Nexus 9508 ACI-Mode Switch Hardware Installation Guide
Removing a Fabric Module
65