Table of Contents
Advertisement
Setting IPv4 Addresses
The machine's IPv4 address can either be assigned automatically using DHCP or entered manually.
By default, the IPv4 address is set automatically when connected to a wired or wireless LAN, but you can set it or
change it manually according to your usage environment and purpose.
This section describes how to configure the settings using the operation panel.
You can also set the IPv4 address using Remote UI from a computer after it has been set on the machine.
the Machine from a Computer (Remote UI)(P. 178)
Administrator privileges are required. The machine must be restarted to apply the settings.
1
On the operation panel, select [Menu] in the [Home] screen, and press
Screen(P. 81)
2
Press [Preferences]
[IP Address Settings]
If the login screen appears, enter the System Manager ID and PIN, and then press
ID and PIN(P. 4)
3
Set the IP address.
When Manually Setting the IP Address
1
Select [Auto Acquire] and press
➠
The [Auto Acquire] screen is displayed.
2
Press [Select Protocol]
3
Press [Auto IP]
4
Select [<Apply>] and press
➠
The [IP Address Settings] screen is displayed.
5
Select [Manually Acquire] and press
➠
The IP address input screen is displayed.
6
Enter the IP address and press
7
Enter the subnet mask and press
8
Enter the gateway address and press
When Assigning an IP Address Automatically
1
Select [Auto Acquire] and press
Setting Up
[Network]
.
.
[Off]
.
[Off]
.
.
.
.
.
.
.
50
[TCP/IP Settings]
95LW-016
Managing
.
[Home]
[IPv4 Settings]
.
System Manager
Advertisement
Table of Contents
