To Set the Beep
(1) Press Utility and choose System, enter the second page of the menu.
(2) Press F1 to select Beep.
(3) Press F1 to switch between On/Off. On is to activate the sound when the system
informs you. Off is to deactivate it.
View System Information
(1) Press Utility and choose System, enter the second page of the menu.
(2) Press F2 to select Sys info. You can view the Version and Serial number.
To Set the Clock Source
The waveform generator provides an internal clock source and also accepts external clock
source input from the [Ref Clk/Counter In] connector at the rear panel. It can also output
a clock source from the [Ref Clk Out] connector for other device to use.
Note:
The amplitude of the [Ref Clk/Counter In] input signal must be over 1 V.
(1) Press Utility and choose System, enter the second page of the menu.
(2) Press F3 to select CLK Sou.
(3) Press F3 to switch between Internal/External.
To Use the Power Amplifier (Optional)
The Power Amplifier module is optional for the generator, can be used in power circuit
test, power components measurement, constant voltage output, magnetization
characteristic measurement, scientific research and education.
Features:
Gain: X10;
Virtual Value of Sine Output Power: 10W;
Input Impedance: 50 kΩ;
The integrated output protection circuit (overcurrent protection and internal
temperature abnormal protection) provided with ensures the instrument is working
stably and safely;
Full power bandwidth: DC – 100 kHz.
How to Use:
Connect the input signal to the P-Input connector on the rear panel; the P-Output
connector outputs the amplified signal.
5.Front Panel Operation
38