Table of Contents
Advertisement
① Power socket
② Fuse
③ Power switch
④ USB (type B)
connector
⑤ Ext Mod In
Connector
⑥ Ext Trig/Burst/Fsk
In connector
⑦ Ref Clk/Counter In
connector
⑧ Ref Clk Out
connector
⑨ P-Output
connector
⑩ P-Input connector
User Interface
⑪
⑩
⑨
⑧
⑦
Figure 4-3 User interface (take Sine for instance)
① Current channel
4.Quick Start
AC input connector
The rating is 250 V，F2AL.
Switch between 110 V and 220 V.
This can be used to connect a USB type B controller.
Connect with an external device, such as connected to a PC
and controlled via PC software.
External modulation input, use it as external signal source.
This signal can be used as external signal source in Sweep,
Burst and FSK mode.
To accept an external clock signal, or to accept the input
signal of counter. (See page 38, To Set the Counter)
To synchronize generators. Output a clock signal generated
by the crystal inside the generator. (See page 38, To Set the
Clock Source)
Signal output for the Power Amplifier.
See page 38,
Signal input for the Power Amplifier.
See page 38,
①
⑥
To Use the Power Amplifier (Optional)
To Use the Power Amplifier (Optional)
②
⑤
7
③
④
Advertisement
Table of Contents
