Table of Contents
Advertisement
from the start frequency to the stop frequency at the sweep rate you specify. Sweep can
be generated by Sine, Square or Ramp Waveforms.
Load
Sweep Type
Sweep Waveform
Source
Figure 5-21: The User Interface of Sweep Mode
How to set the parameters of Sweep
(1) When the output signal is Sine, Square or Ramp waveform, press the Mod button,
then press F2 to select Sweep to enter the Sweep mode.
(2) Press
,
instance, press
parameters, please refer to To set signals on page 12. Press
return to the Sweep mode interface.
(3) Press
to set Sweep Time, the Time Span of the Sweep for which the
F1
Frequency changes from the Start Frequency to Stop Frequency.
(4) Press F2 to select the Sweep Type. Linear means setting the Sweep with linear
spacing; Log means setting the Sweep with logarithmic spacing.
(5) Use Start Freq and Stop Freq or Center Freq and Freq Span to set the range of the
frequency. Press F3 to select Sta_Freq or Cen_Freq, and set the desired value.
(6) Press F4 to select StopFreq or FreqSpan, and set the desired value.
(7) Press F5 to select NextPage, press it again to enter the next page.
(8) Press F1 to select the source. Internal means using the internal source. External
means using the Ext Trig/Burst/Fsk In connector in the rear panel to input the
external signal. Manual means choosing manual trigger; in Sweep interface, press the
5.Front Panel Operation
Current Parameter
Start
Frequency
Sweep Waveform
Amplitude
or
button to choose the waveforms. Take Sine for
to display the waveform and parameters. You can change the
Sweep Time
Stop
Frequency
Sweep Waveform
Offset
30
Sweep Waveform
button again to
Advertisement
Table of Contents
