Lincoln Electric FineLine 300HD Operator's Manual page 55

BK8053-000107 Rev D
4) Select Internet Protocol Version 4 (TCP/Ipv4) and then the Alternate
Configuration tab. In the User configured section, enter the IP address and
Subnet mask shown below.
Firewall Exclusions
If CutLinc Server is not connecting, inbound and outbound exclusion may need to be
added to the network firewall to allow data to pass through.
MultiCast IP:
Multicast Port:
TCP Address:
TCP Server Port:
3.17.2 FineLine User Interface (UI)
Installation
If the System uses a non-Lincoln Electric HMI (CNC Controller or Industrial
Computer), the FineLine UI must be installed. Installation of the FineLine UI is not
required when using a Lincoln Electric provided HMI.
Contact Factory for FineLine Service Installer and then follow Section 6.5.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
224.0.180.90
17272
Any
48548
Page 55 of 132
FineLine 300HD Plasma System