Replacing System Components - Lincoln Electric FineLine 300HD Operator's Manual

BK8053-000107 Rev D

7.3 Replacing System Components

If it becomes necessary to replace any System component containing a MAC
address – Power Supply, Gas Controller, HMI, or optional APC – after the System
has been commissioned, follow these steps to re-commission the System:
Remove primary power to the Power Supply. For multi-torch setups, ensure
this is the Power Supply physically connected to the serviced torch.
Disconnect power to the HMI and Ethernet router/switch.
Replace the System component and remake all necessary connections.
Follow the steps in Section 3.18 to Commission the System.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
DANGER
Electric Shock Can Kill.
•
Do not touch electrically live parts or electrode with skin
or we clothing. Insulate yourself from work and ground.
Always wear dry insulating gloves.
•
Disconnect input power before servicing.
•
Do no operate with covers, panels, or guards removed.
•
Only qualified personnel should install, use, or service
this equipment.
Page 109 of 132
FineLine 300HD Plasma System