Lincoln Electric FineLine 300HD Operator's Manual page 107

BK8053-000107 Rev D
Source FLGC
Event
Hex
Code
4117 0x1015
4118 0x1016
4119 0x1017
4120 0x1018
4121 0x1019
4122 0x101A
4123 0x101B
4124 0x101C
4126 0x101E
4127 0x101F
4128 0x1020
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Description
EX OCV TIMEOUT
EX PLASMA TRACKING
EX POSTFLOW TRACKING
EX PREFLOW TRACKING
EX SHIELD TRACKING
EX CNC START DEASSERTED
EX BOOST ABORT
EX START PROHIBITED
EX ARC HOLD TIMEOUT
EX APC PLASMA START TIMEOUT
EX APC WATER COMMAND
TIMEOUT
Page 107 of 132
FineLine 300HD Plasma System
Possible Resolution
Power Supply was
commanded on but no open
circuit voltage (OCV) was
reported. Check Power Supply
indicator LED for faults. Check
error log for events prior to the
OCV timeout event.
Output pressure does not
track to commanded output
pressure. Verify correct
consumables are installed.
Check for restriction or
blockage in gas supply hose
and torch leads. Check for
leaks at gas controller output
connections and torch
connections.
Start signal has been
removed.
High current boost for piercing
has timed out.
Check ESTOPs are clear, RT
communication with power
supply is operational, gases
have been purged and if APC
fitted shield water has been
purged. If all conditions are
clear then cycle power (ON
Button to off and back to on).
Wait 5s between off and
turning back on.
Second CNC start signal pulse
(rising edge) not received
within arc hold timeout (TTS).
Extend TTS or generate the
second CNC start signal pulse
closer to the first.
APC dispense operation did
not complete in time. Cycle
power to APC and GC as an
unrecoverable communication
error has occurred.
APC water shield on/off
operation did not complete in
time. Cycle power to APC and
GC as an unrecoverable
communication error has
occurred.