10�1 Parameter Setting In General; 10�1�1 Select Submenu; 10�1�2 Change To The Process Value Display (Run Mode) - IFM SD1540 Operating Instructions Manual

The parameters can also be set via the IO-Link interface�
Special feature for parameter setting via IO-Link:
► Enter SP, rP, FH, FL, ASP, AEP for volume flow monitoring in % of the
final value of the measuring range and transmit the parameter setting to
the device�
> The unit internally converts the percentage values into absolute num-
bers (→ 10.6.2 Standard unit of measurement for volumetric flow) and
transmits the calculated value back to the parameter setting software
after re-reading of the unit�
Functions which can only be set via the IO-Link interface: → 4.9.1�
10.1 Parameter setting in general
1� Change from the RUN mode to the main menu
2� Select the requested parameter
3� Change to the setting mode
4� Change the parameter value
5� Acknowledge the set parameter value
6� Return to the RUN mode
If [�� Locked via Communication] is displayed when an attempt is made to
modify a parameter value, an IO-Link communication is active (temporary
locking)�
If [�� Locked via system] is displayed, the sensor is permanently locked
via software� This locking can only be removed with a parameter setting
software�
10.1.1 Select submenu
1� Press [●] to change from the process value display to the main menu�
2� Press [▼] to select the menu EF and press [●]�
3� Press [▼] to select the submenu and press [●]�
10.1.2 Change to the process value display (RUN mode)
There are 2 possibilities:
[●]
[▲] or [▼]
[●]
[▲] or [▼] > 1 s
[●]
> 30 seconds (timeout)
UK
35