Table of Contents
Advertisement
3-18
INSTALLING YOUR TUBE-ICE
Ice Bin Thermostat Sensor Installation Each machine is equipped with an electronic ice bin
thermostat. To assure proper protection for the machine, the sensor of the ice bin thermostat must be
located so that ice will contact it when the bin is full (See FIGURE 3-11). The distance between the
ice chute and the sensor allows space for the machine to make an additional discharge of ice AFTER
the ice contacts the probe WITHOUT the ice building up into the discharge opening of the chute
Note: The probe should also be mounted on the back side of the bracket, opposite of the front of the
bin to reduce the possibility of damage from ice removal equipment.
The control panel is electrically connected so that the bin thermostat will stop the machine only upon
the completion of a harvest period.
When both cylinder and crushed ice are produced and separately stored in a divided bin, the control
sensor of thermostat BT2 is placed in the crushed ice section of the storage bin (left side) and the
control sensor of thermostat BT1 is placed in the cylinder ice section (right side of bin).
4/2/14
®
MACHINE
Note: Drip loop not necessary for Electronic Thermostat
FIGURE 3-11
Ice Bin Thermostat Location
03TA Service Manual
.
Advertisement
Table of Contents
