Table of Contents
Advertisement
3-2
INSTALLING YOUR TUBE-ICE
FIGURES 3-2 & 3-3 illustrate two methods of lifting & setting Tube-Ice
bin.
You need:
forklift truck with adequate load and height capacities
(8) 2X4 wood blocks 8 in. long
(2) wooden 2X4's measuring 3-ft. long
pry bar
Step 1.
Position Tube-Ice
Step 2.
Stack wood blocks in each corner of the drip pan on top of the ice storage bin.
Step 3.
Lift and set Tube-Ice
Step 4.
Remove forklift.
Step 5.
Stack 3-ft. long 2X4's beside drip pan, overlapping front and back of bin.
Step 6.
Using a pry bar with fulcrum on 2X4's, raise side of machine enough to remove TOP wood
blocks.
Step 7.
Repeat steps 5 and 6 on other side.
Step 8.
With machine sitting on one (1) block under each corner, repeat steps 5, 6, and 7 remove
remaining blocks. Drip pan flanges may bend slightly.
Step 9.
Straighten bent drip pan flanges.
Step 10. Check alignment of ice chute to bin opening.
4/2/14
®
MACHINE
!
The approximate weight of the machine is 2000 pounds.
Always use equipment with adequate load-carrying capacity.
!
CONTROL PANEL
& SWITCH BOX
Forklift-&-Blocks Method
®
machine on forks.
®
machine on wood blocks.
!
Do not remove top AND bottom blocks at the same time.
!
CAUTION
!
CAUTION
!
REMOVE CASINGS FROM MODEL HE60
BEFORE PLACING MACHINE ON BIN
ICE STORAGE BIN
FIGURE 3-2
CAUTION
!
CAUTION
!
®
machine on an ice storage
TUBE-ICE MACHINE
WOOD BLOCKS
TWO (2) EACH CORNER
03TA Service Manual
Advertisement
Table of Contents
