DFI SD100-H110/Q170 User Manual page 32

ACPI Settings
This section is used to configure the system ACPI parameters.
InsydeH20 Setup Utility
Advanced
ACPI Configuration
Wake on LAN <Enabled>
After G3 <S0 State>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
Wake on LAN
This field use to enable or disable the LAN signal to wake up the system.
After G3
This field is to specify what state to go when power is re-applied after a power
failue (G3 state).
S0 State The system working state.
S5 State Off, except for trickle current to devices such as the power button.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Determines the action tak-
en when the system power
is off and a PCI Power
Management Enable wake
up event occurs.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

CPU Configuration
This section is used to configure the CPU.
Advanced
CPU Configuration
Intel(R) SpeedStep(tm) <Enabled>
Turbo Mode <Enabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
Intel(R) SpeedStep(tm)
This field is used to enable or disable the Intel Enhanced SpeedStep Technology.
Turbo Mode
Enable or disable the turbo mode.
32
InsydeH20 Setup Utility Rev. 5.0
Allows more than two fre-
quency ranges to be sup-
ported.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com