Star Micronics TSP200 Series Programmer's Manual page 41

Commands to Move the Print Position
Line feed
FUNCTION
CODE <LF>
0A
HEX
Prints the current line and feeds the paper to the next line.
REMARKS
Carriage return
FUNCTION
<CR>
CODE
0D
HEX
Prints the current line and feeds the paper to the next line.
REMARKS
This command is ignored when CR code is invalid.
Feed paper n lines
FUNCTION
<ESC> "a"
CODE
1B
HEX
Prints the current line and feeds the paper n lines (where n is
REMARKS
between 1 and 127).
Form feed
FUNCTION
<FF>
CODE
0C
HEX
Feeds the paper to the top of the next page, according to the page
REMARKS
length set by <ESC>"C"n or <ESC>"C"<0>n when memory switch
1-2 is set to 0. If memory switch 1-2 is set to 1, the paper is fed 18 mm,
cut fully, and then feed back 18 mm. The print position is at the left
margin in both cases.
Horizontal tab
FUNCTION
<HT>
CODE
09
HEX
Moves the print position to the next horizontal tab stop. Ignored if
REMARKS
there is no next horizontal tab stop on the current line.
n
61 n
– 37 –