Star Micronics TSP200 Series Programmer's Manual page 43

One time n/4 mm backfeed
FUNCTION
CODE
<ESC> "j"
1B
HEX
Feeds the paper back n/4mm once only.
REMARKS
The value of n is 1 to 255.
Space setting for one line is not changed.
This command can also feed the paper back to the page before the
current page. In this case, the position of the line on the previous
page is determined by the page length control.
One time n/8 mm feed
FUNCTION
CODE
<ESC> "I"
1B
HEX
Performs a line feed n/8mm once only.
REMARKS
The value of n is 1 to 255.
Space setting for lines is not changed.
Set vertical tab stops
FUNCTION
CODE <ESC> "B"
1B
HEX
Cancels all current vertical tab stops and sets new vertical tab stops
REMARKS
at lines n1, n2, etc., where n1, n2, etc. are numbers between 0 and
255. A maximum of 16 vertical tab stops can be set.
The tab stops must be specified in ascending order; any violation
of ascending order terminates the tab stop list. Standard termina-
tion is by the <0> control code.
The vertical tab stops are set in terms of the current line spacing and
do not move if the line spacing is changed later.
n
6A n
n
49 n
n1 n2
42 n1 n2
– 39 –
... <0>
... 00