Star Micronics TSP200 Series Programmer's Manual page 56

Star micronics tsp200: reference guide

Hide thumbs Also See for TSP200 Series:

Table of Contents

Commands to Control Auto Cutter

Full-cut command to the auto cutter

FUNCTION

CODE

<ESC> "d"

HEX

Cuts the paper fully when memory switch 2-C is set to 0. If memory

REMARKS

switch 2-C is set to 1, the paper is fed to 18 mm and cut fully.

When auto cutter is invalid, this command is not valid.

Partial-cut command to the auto cutter

FUNCTION

<ESC> "d"

CODE

HEX

Cuts the paper partially when memory switch 2-C is set to 0. If

REMARKS

memory switch 2-C is set to 1, the paper is fed to 18 mm and cut

partially.

"0"

or <ESC> "d"

"1"

or <ESC> "d"

– 52 –

<0>

<1>

Table of Contents

Show Quick Links

Table of Contents