Peripheral Unit Drive Circuit - Star Micronics TSP200 Series Programmer's Manual

6. PERIPHERAL UNIT DRIVE CIRCUIT

A drive circuit for driving peripheral units (such as cash drawers) is featured on
the main logic board of this printer. A modular connector for driving peripheral
units is featured on the output side on the drive circuit. When using this circuit,
connect the cable for the peripheral unit. (Cables must be prepared by the user.)
Use cables which meet the following specifications.
1. Use the modular plug as shown in Figure 6-1.
2. Separate ground wire is required for Europe only.
3. If the printer is to be used in Europe, the noise filter should be attached to the
cable, as shown in Figure 6-2.
CAUTION: DO NOT connect any other plug to the peripheral unit connector.
Modular plug MOLEX 90075-0007,
AMP641337 or JAPAN BURNDY B-66-4
Figure 6-1. Cable specifications for peripheral unit.
Shield
Wire lead
Separated Ground wire
connected to shield (Europe only).
– 16 –