Epson TM-U220-i Technical Reference Manual page 79

Automatic Update
1. Connect this product to a network
Connect this product to a network and turn on the product.
2. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig/
When SSL is enabled:
( U "Starting EPSON TMNet WebConfig" on page
3. Set automatic update of Web contents
From [Update Settings] in the [Web Service Settings] menu, set automatic update of Web contents.
Select [Enable] from "Automatic Update".
Configure the settings such as the update frequency and timing of Web contents and the URL of the
server where the file to be obtained is stored.
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
( U "Web Service Settings - Web Contents - Update Settings" on page
https://[This product's IP address]/webconfig/
97)
106)
Chapter 2 Setup
2
79