Appendix; Product Specifications - Epson TM-U220-i Technical Reference Manual

Appendix

Product Specifications

Printing method
*1
Autocutter Cutting method
Cutting type
Interfaces USB host port
USB device port
Serial
microSD card
Ethernet
Wireless LAN
Drawer kick
9-pin serial impact dot matrix
By separated-blade scissors
Partial cut (one point left uncut) (standard factory settings)
Full cut (completely cut off) (optional factory setting)
 Standards: USB2.0 (High/Full/Low speed)
 Number of ports: 2 ports
 Connector: Type A
 Provided current: Within 500 mA for each port
 Standards: USB2.0 (High speed)
 Number of ports: 1 port
 Connector: Type B
 Data transmission: Bit serial
 Synchronization: Asynchronous
 Flow control: XON/XOFF control or DTR/DSR control
 Signal levels: MARK = -3 to -15 V Logic "1"/ OFF
 Data format: Data length: 7 bits, 8 bits
 Stop bits: 1 or more
 Baud late: Maximum 115200 bps (bps: bits per second)
 Parity: Odd, Even, None
 Connector: D-sub 9 pin (Male)
 No. of slots: 1 slot
 Connector: Push-Push type
 Supported card: micro SD card, micro SDHC card
 Notes:
Make sure that the product power is turned off before insert-
ing or removing a microSD card.
Use a microSD card with wear leveling.
10Base-T/100Base-TX
*2
IEEE802.11b/g/n
 Pin: 6 pin
 Connector: Modular
(only for cash drawer)
Within 600 mA for both ports
SPACE = +3 to +15 V Logic "0"/ ON
Appendix
137