Registering Contacts For Email, Network, Or Ftp Scanning - Web Config - Epson ES-C380W User Manual

• For an FTP location, enter the FTP server port number in the Port Number field. If there is a
firewall between the product and FTP server, select the Connection Mode field and select
Passive Mode.
12. Select OK.
Parent topic:
Related tasks

Registering Contacts for Email, Network, or FTP Scanning - Web Config

Registering Contacts for Email, Network, or FTP Scanning - Web Config
You can register a list of contacts for scanning to email or to a network folder or FTP server using Web
Config and your computer's internet browser.
Before you begin, make a note of the IP address or host name of the scanner so you can enter it in these
steps. Select Settings > Network Settings > Network Status on the product's control panel, and select
Wi-Fi Status or Wi-Fi Direct Status to confirm the product's IP address.
1. Launch an internet browser on a computer that is using the same network as your product.
2. Type your product's IP address into the address bar and press Enter.
3. You may see a warning displayed in your browser when you start Web Config; this is not a problem.
Depending on your browser, select the option to view the web page anyway.
4. In the upper right corner of the screen, click Log in and enter the Administrator password.
Note: If this is your first time logging in, use the following default values:
• User name: none (blank)
• Password: If there is a "PASSWORD" label attached to the back of your product, enter the 8-digit
number shown on the label. If there is no "PASSWORD" label, enter the serial number shown on
the label attached to your product.
5. Click OK.
6. Click on the Scan tab, then click Contacts.
7. Select the number you want to use for the contact you are adding and click Edit.
8. Do one of the following:
• To create a contact for scanning to email, select Email as the Type setting.
• To create a location for scanning to a network folder or FTP, select Network Folder (SMB) or FTP
as the Type setting.
Starting a Scan Using the Product Control Panel
131