Table of Contents
Advertisement
Available languages
Available languages
EN
2.- USING THE HEATER
Air outlet grill
Thermostat Switch
Check the safe condition of the device before using.
•
The device is in good conditions and there are no visible defects.
•
All parts of the device are firmly attached.
•
The power switch of the device is in OFF position (O) before plugging the heater to the power supply.
Switching on the Heater
Plug in the appliance, and turn the thermostat switch to its maximum position.
Heating Power
Then turn the heat rotary switch to the desired position. While working, the indicator light will be on.
•
Rotary switch on "I": Low heating power (1000 W). The heater blows warm air, working at 1000W.
•
Rotary switch on "II": High heating power (2000 W). The heater blows warm air, working at 2000W.
•
Rotary switch on " ": The heater blows cool air.
•
Rotary switch on "O": The heater stops working, the indicator light will be off.
Thermostat Temperature Adjustment
Adjust the thermostat switch to suitable position for desired temperature setting.
•
Check if the thermostat switch is on the maximum position.
•
When you feel the room temperature comfortable, turn the thermostat switch anti-clockwise slowly to the minimal
position until the appliance stops working.
Then the thermostat switch will keep the room temperature at the desired temperature automatically.
You can also turn the thermostat switch anti-clockwise to the minimum position or turn the thermostat switch clockwise to
maximum position to make the temperature lower or higher.
Switching off
Set heating power switch to [O] position.
Note: The device is supplied with a tip-over switch. In case the appliance falls dawn, the tip-over switch will turn off the heater
automatically.
Handle
Power Indicator Light
Air inlet grill
Power Level Switch
5
Advertisement
Table of Contents
