Table of Contents
Advertisement
Parking-Brake Lever
Whenever you shut off the engine, engage the
parking brake
(Figure
10) to prevent the machine from
accidentally moving. If the machine is parked on a
steep grade, ensure that you engage the parking
brake.
•
To engage the parking brake, pull back on the
parking-brake lever.
•
To disengage the parking brake, push the
parking-brake lever forward.
Note:
Disengage the parking brake before
moving the machine.
•
If you park the machine on a steep uphill or
downhill grade, shift the transmission into P (
and engage the parking brake. Place chocks at
the downhill side of the wheels.
Figure 10
1. Parking-brake lever
Hydraulic-Lift Lever
The hydraulic lift raises and lowers the bed. Move
the hydraulic-lift lever rearward to raise the bed, and
forward to lower it
(Figure
Important:
When lowering the bed, hold the lever
in the forward position for 1 to 2 seconds after the
bed contacts the frame to secure it in the lowered
position. Do not hold the hydraulic lift in the raise
or lower position for more than 5 seconds, once
the cylinders reach the end of their travel.
PARK
11).
1. Lower the bed
)
2. Raise the bed
3. Locked
Hydraulic-Lift Lock
The hydraulic-lift lock secures the lift lever, so that the
hydraulic cylinders do not operate when the machine
is not equipped with a bed
lift lever in the O
for attachments.
Speed-Range Lever
Use the speed-range lever
the 4 work-speed ranges for precise control of the
maximum ground speed or a transport speed range
g028610
for moving the machine between job sites.
1. Speed-range lever
2. T (transport range)
3. D (high range)
15
Figure 11
4. Unlocked
5. Hydraulic-lift lock
6. Hydraulic-lift lever
(Figure
11). It also locks the
position when using the hydraulics
N
(Figure
12) to select 1 of
Figure 12
4. C (mid-high range)
5. B (mid-low range)
6. A (low range)
g024361
g024320
Advertisement
Table of Contents
