Table of Contents
Advertisement
1. Disconnected hoses
5.
On the other machine, connect the 2 hoses to
the coupler still in the coupler bracket (connect
the top hose to the top coupler and the bottom
hose to the bottom coupler)
6.
Cap the unused fittings.
1. Jumper hoses
7.
Keep all bystanders away from the machines.
8.
Start the second machine and move the lift lever
to the raise position, which raises the disabled
cargo bed.
9.
Move the hydraulic-lift lever to the N
position, and engage the lift-lever lock.
10.
Install the bed support onto the extended lift
cylinder; refer to
33).
Note:
With both the machine turned off, move
the lift lever back and forth to remove the system
pressure and ease the disconnection of the
quick couplers.
11.
After completing the operation, remove the
jumper hoses and connect the hydraulic hoses
to both machines.
Figure 84
2. Jumper hoses
(Figure
85).
Figure 85
EUTRAL
Using the Bed Support (page
Important:
levels, in both machines, before resuming
operation.
g002429
g019543
61
Check the hydraulic fluid
Advertisement
Table of Contents
