Toro Workman 07390H Operator's Manual page 49

1. Cap
2. Max mark (reservoir)
5. If the fluid level is low, perform the following:
A. Wipe clean the area around the cap for the
reservoir (Figure
B. Remove the cap from the reservoir
61).
C. Add the specified fluid to raise the level
midway between the Min and Max marks on
the side of the reservoir
D. Install the cap hand tight
6. Align the holes in the control-cover plate to the
holes in the seat base
7. Secure the plate to the base with the 6
hex-washer screws
removed in step 2.
8. Thread the knobs onto the rods for the
hydraulic-lift lever and the speed-range lever
(Figure 60).
Adjusting the Speed Control
Important:
The minimum controlled speed for
the machine is 4.0 kph (2.5 mph) at full engine
speed. Controlling the machine speed slower that
4.0 kph (2.5 mph) results in excessive belt and
clutch wear.
1. Drive the machine in speed range A (low range),
B (mid-low range), C (mid-high range), or D
(high range) in order to determine which speed
range includes the maximum-ground speed that
you want to set; refer to .
Note:
Use the speedometer to determine the
speed that the machine is traveling.
2. Remove the knobs from the hydraulic-lift lever
and the speed-range lever
Figure 61
3. Min mark (reservoir)
4. DOT 3 brake fluid
61).
(Figure 61).
(Figure 61).
(Figure 60).
(Figure 60) that you
(Figure 60).
3. Remove the 6 hex-washer screws (#10 x 3/4
inch) that secure the control-cover plate to the
seat base, and remove the cover plate
60).
4. Move the speed-range lever to the T
(
TRANSPORT
5. Loosen the 2 hex-socket screws (5/16 x 3/4 inch)
that secure the detent plate to the lever-support
bracket
g025530
(Figure
1. Lever-support bracket
2. Hex-socket screws
6. Move the detent plate in one of the following
directions:
•
Move the detent plate forward to increase
the maximum ground speed limit
•
Move the detent plate rearward to decrease
the maximum ground speed limit
7. Tighten the 2 hex-socket screws (5/16 x 3/4
inch) to 19.8 to 25.4 N∙m (14.6 to 18.7 ft-lb).
8. Drive the machine with the speed control set
to speed range for which you are setting the
maximum ground speed limit. If the maximum
ground speed limit is too fast or too slow, repeat
steps
ground speed limit is attained.
9. Align the holes in the control-cover plate to the
holes in the seat base
10. Secure the plate to the base with the 6
hex-washer screws
removed in step 3.
11. Thread the knobs onto the rods for the
hydraulic-lift lever and the speed-range lever
(Figure
49
) position (Figure
(Figure 62).
Figure 62
3. Detent plate
1 through 8 until the correct maximum
(Figure
(Figure
60).
(Figure
62).
g025550
(Figure 62).
(Figure 62).
60).
60) that you