Toro Workman 07390H Operator's Manual page 40

Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check
the engine-oil level. (Check the oil
level before and after the engine is
first started and daily thereafter.)
Note:
The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If the engine has already ran, shut it off and wait
for at least 10 minutes before checking the oil level.
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Remove the dipstick and wipe it with a clean rag
(Figure 42).
Figure 42
1. Dipstick tube
2. Filler neck
5. Insert the dipstick into the tube and ensure that
it seats fully.
6. Remove dipstick and check the oil level
42).
7. If the oil level is low, remove the filler cap
42) and add enough oil to raise the level to the
Full mark on the dipstick.
Note:
When adding oil, remove dipstick to
allow proper venting. Slowly pour the oil into the
filler neck, and check the level often during this
process. Do not overfill the engine with oil.
g025526
3. Filler cap
4. Dipstick
(Figure
(Figure
1. Note the clearance between the fill device and the oil-fill
neck.
Important:
When adding engine oil or filling
oil, there must be clearance between the oil
fill device and the oil fill neck in the valve
cover as shown in
is necessary to permit venting when adding
oil.
8. Install the filler cap onto the filler neck
42).
9. Firmly install the dipstick
Changing the Engine Oil and Filter
Service Interval: After the first 50 hours
Every 200 hours
1. Raise the bed and place the safety support on
the extended lift cylinder to hold up the bed.
2. Align a large drain pan under the oil-drain plug
(Figure 44).
40
Figure 43
Figure 43. This clearance
(Figure
(Figure 42).
g002373