Gun Cable Connection With Fast-Mate Connection; 10-Series Double Head Drives Water Connections (For Water Cooled Guns; 10-Series Double Head Drives; Synergic 7F Head Drives - Lincoln Electric 10357 Operator's Manual

A-8
Gun Cable Connection with Fast-Mate
Connection
1. Check that the drive rolls, feeder guide tubes and
gun connector guide tube are appropriate for the
electrode size being used. If necessary, change
them per "Wire Drive Roll Kits" in this section.
2. Connect gun to gun connector making sure all pins
and gas tube line up with appropriate holes in con-
nector. Tighten gun by turning large nut on gun
cable clockwise.

10-SERIES DOUBLE HEAD DRIVES

WATER CONNECTIONS
WATER COOLED GUNS)
10-Series Double Head Drives:
K590-4 Water Connection Kit installed for each water
cooled gun. (See INSTALLATION AND ACCES-
SORIES).
Using male quick-connect fittings, connect the water
hoses to the coolant inlet and outlet on the back of the
wire drive. Connect the other ends of these hoses to
the appropriate ports on the water cooling units.
In the event the water line fittings on your water
cooled gun are incompatible with the female quick
connects on the front of the wire drive, male quick-
connects (L.E. Part No. S19663) are provided in the
Kit for installation on 3/16" (5 mm) I.D. hose
(Customer to provide appropriate clamps). The feeder
connectors self seal when disconnected.
Synergic 7F Head Drives (K679)
K682-2 Water Connection Kit installed. (See ACCES-
SORIES).
Using hose clamps provided with the K682-2 kit, con-
nect appropriate water hoses to the coolant inlet and
outlet fittings on the back of the K682-2 Kit. Connect
the other ends of these hoses to the appropriate ports
on the water cooling units.
In the event the water line fittings on your water
cooled gun are incompatible with the female quick
connects on the front of the K682-2 Kit male quick-
connects are provided with the kit for installation on
3/16 (5 mm) I.D. hose (Customer to provide appropri-
ate clamps). The feeder connectors self seal when
disconnected.
INSTALLATION

GMAW Shielding Gas

• Never lift welder with cylinder attached.
• Never allow welding electrode to touch cylinder.
• Keep cylinder away from welding or other live elec-
trical circuits.
(FOR
SEE AMERICAN NATIONAL STANDARD Z-49.1,
must have a
"SAFETY IN WELDING AND CUTTING" PUBLISHED
BY THE AMERICAN WELDING SOCIETY.
------------------------------------------------------------------------
NOTE: Gas supply pressure must be regulated to a
maximum of 80 psi(5.5 bar).
Customer must provide a cylinder of shielding gas, a
pressure regulator, a flow control valve, and a hose
from the flow valve to the gas inlet fitting of the wire
drive unit.
Connect a supply hose from the gas cylinder flow
valve outlet to the 5/8-18 female inert gas fitting on the
back panel of the wire drive or, if used, on the inlet of
the Gas Guard regulator. (See Below).
Gas Guard Regulator - The Gas Guard Regulator is
an optional accessory (K659-1) on these models.
:Must have a
Install the 5/8-18 male outlet of the regulator to the
5/8-18 female gas inlet on the back panel of the wire
drive. Secure fitting with flow adjuster key at top.
Attach gas supply to 5/8-18 female inlet of regulator
per instructions above.
DH-10
WARNING
CYLINDER may explode if damaged.
• Keep cylinder upright and chained to
support.
• Keep cylinder away from areas where
it may be damaged.
BUILDUP OF SHIELDING GAS may
harm health or kill.
• Shut off shielding gas supply when not
in use.
A-8