Belt & Deck Cleaning; Calibration - Spirit XT385 Owner's Manual

BELT AND DECK CLEANING & CALIBRATION PROCEDURE
Belt & Deck Cleaning
To clean your treadmill belt:
1. Ensure that your machine is off, and that the power cord
is unplugged to minimize risk of injury.
2. Grab one edge of the treadmill belt, and lift slightly to
expose the area between the top of the treadmill base
and the running belt.
3. Do a visual check for any dirt or debris accumulation.
4. Should dirt and debris be present, slide a towel or
cleaning cloth between the treadmill belt and top of the
treadmill base until you can grasp one end on each side.
(The cleaning cloth should be longer than the running
belt is wide to achieve this.)
5. Using both hands, drag the cleaning cloth up and down
the length of the treadmill base 1-2 times.
6. For excessive dirt accumulation, rotate the belt halfway,
and repeat step 5. Continue until your cleaning cloth is no
longer picking up any dirt.
7. Remove cleaning cloth from treadmill before plugging
back in.
Calibration Procedure
1. Remove the Safety Key.
2. Press and hold Start and Speed + buttons and at the same time
replace the Safety Key. Continue to hold Start and Speed keys
until the window displays "Factory settings", then press the
Enter key.
3. You will now be able to set the display to show Metric or English
settings (Miles vs. Kilometers). To do this, press the incline +/
- key to show which you want, then press Enter(The maximum
speed value is displayed in the speed window, and the maximum
elevation value is displayed in the incline window.)
4. Adjust the maximum speed (if needed) to 12.0 mph and then
press Enter.
5. Adjust the minimum speed (if needed) to 0.5 mph and then
press Enter.
6. Make sure the wheel size diameter is 2.43 then press Enter.
7. Grade return – On (This allows the incline to return to zero
when Stop button is pressed. For sale in Europe, EU standards
require this to be off )
8. Press Start button to begin calibration. The process is
automatic; the speed will start up without warning, so do not
stand on the belt.
46