Spirit XT385 Owner's Manual page 45

MAINTENANCE & CARE - CONTINUED
Treadbelt Tracking Adjustment
The treadmill is designed so that the tread-belt remains
reasonably centered while in use. It is normal for some belts
to drift near one side while in use, depending on a user's gait
and if they favor one leg. But if during use the belt continues
to move toward one side, adjustments are necessary.
SETTING TREAD-BELT TRACKING
An 6mm Allen wrench is provided for this adjustment. Make
tracking adjustments on the left side bolt. Set belt speed at 3
mph. Be aware that a small adjustment can make a dramatic
difference which may not be apparent right away.
If the belt is too close to the left side, then turn the bolt only
a 1/4 turn to the right (clockwise) and wait a few minutes for
the belt to adjust itself. Continue to make 1/4 turns until the
belt stabilizes in the center of the running deck.
If the belt is too close to the right side, turn the bolt
counter-clockwise. The belt may require periodic tracking
adjustment depending on use and walking/running
characteristics. Some users may affect tracking differently.
Expect to make adjustments as required to center the
tread-belt. Adjustments will become less of a maintenance
concern as the belt is used. Proper belt tracking is an owner
responsibility common with all treadmills.
43
If running belt slips while walking on it, users can adjust tension of the runni
screws on rear rollers of both sides with L Allen Wrench (132), which is inclu
PS . During adjustment, while turning rear rollers' screws, be sure to keep ru
STEP 5.
balanced on both sides, otherwise the belt shifts from higher tension end to
Place Tablet Holder (169) on Console Assembly(Top) (53) and use Phillips He
!
Damage to the running belt resulting from improper
(148) to tighten 3 pcs of M5 × 25mm_Phillips Head Screw (166).
tracking / tension adjustments is not covered under
the Spirit Fitness warranty.
NOTE: Please Tighten All Screws After All Components Assembly Comp
If running belt slips while walking on it, users can adjust tension of the running
screws on rear rollers of both sides with L Allen Wrench (132), which is include
PS . During adjustment, while turning rear rollers' screws, be sure to keep run 132
balanced on both sides, otherwise the belt shifts from higher tension end to th
Use Lubricant (30) to lubricate running deck beneath running belt after using
Only a few droplets are sufficient for lubrication. Avoid applying too much lub
catch dirt and affect electronic control system.
132
Use Lubricant (30) to lubricate running deck beneath running belt after using f
Only a few droplets are sufficient for lubrication. Avoid applying too much lubri
132
30
132