Spectralink rcc400 base station: product support bulletin (1 page)
Summary of Contents for SpectraLink 3000
Page 1
Installing the Outdoor Base Station Link Wireless Telephone System Part Number: 72-0050-00 Issue D Supplement to: 72-0075-01 and 72-0059-01...
Page 2
No representation or other affirmation of fact contained in this document including but not limited to statements regarding capacity, response-time performance, suitability for use, or performance of products described herein shall be deemed to be a warranty by SpectraLink for any purpose, or give rise to any liability of SpectraLink whatsoever.
SpectraLink Corporation WARNING: Changes or modifications to this equipment not approved by SpectraLink Corporation may cause this equipment to not comply with part 15 of the FCC rules and void the user’s authority to operate this equipment. WARNING: SpectraLink products contain no user-serviceable parts inside. Refer servicing to qualified service personnel.
SpectraLink Corporation 1. About This Document SpectraLink Corporation Model Numbers Related Documents Contacting SpectraLink Icons and Conventions 2. Installing Flush Against a Wall or Hard Ceiling 3. Installing on an I-Beam 4. Installing on a Light Pole or Electrical Pole PN: 72-0050-00-D.doc...
This document covers the installation of the Outdoor Base Station in a variety of situations. It supplements the installation documentation for the Link Wireless Telephone System using either the Link 3000 MCU or the Link 150 M3 MCU. SpectraLink Corporation Model Numbers...
SpectraLink Corporation Installing Flush Against a Wall or Hard Ceiling Items provided: Outdoor enclosure, Base Station Items needed: 4 anchor bolts (length and type depends on wall or ceiling material Base Station is being mounted to) 1. Mark and drill 4 holes into the wall or ceiling, using the mounting flanges of the outdoor enclosure as a guide.
Page 7
SpectraLink Corporation 5. Plug the RJ45 into the RJ48C connector. RJ48C connector 6. Place the Base Station into the enclosure with the side of the Base Station with the mounting hole facing the wall or ceiling. The Base Station should fit tightly into the foam blocks.
SpectraLink Corporation Installing on a Light Pole or Electrical Pole Items provided: Outdoor enclosure, Base Station Items needed: 4 - “Caddy” or “B-Line” 3/8” Beam Clamps 2 - EOG 100 or Equivalent Band Clamps 1. Attach one band to the top flange of the outdoor enclosure using 2 beam clamps (see the figure below).
Need help?
Do you have a question about the 3000 and is the answer not in the manual?
Questions and answers