Table of Contents
Advertisement
How to install the Function Board
Screws (two locations)
Slot cover
Fig.1
Guide rail
Fig.2
1)
Remove the slot cover. (Fig. 1)
f Remove the two screws fixing the slot cover of the projector by
rotating counterclockwise with a Phillips screwdriver. The removed
screws are used to fix the Function Board.
f When removing the second screw, hold the slot cover with your hand
so it will not fall.
f To replace from other Function Board, remove the Function Board
following the procedure in "How to remove the Function Board"
(x page 10).
2)
Install the Function Board to the projector. (Fig. 2)
f Insert the Function Board along the groove of the guide rail at both
sides inside the slot. Insert the bracket firmly all the way in.
3)
Fix the Function Board. (Fig. 3)
f Tighten and fix with the two screws removed in Step 1).
Attention
f The removed slot cover is required when the unnecessary Function Board is removed. Store
it so it can be attached in the future.
Installing the Function Board
Screws (two locations)
Fig.3
ENGLISH - 9
Advertisement
Table of Contents
