Table of Contents
Advertisement
How to install the Interface Board
Screws (4 locations)
Slot cover
Fig. 1
1)
Remove the slot cover. (Fig. 1)
f Remove the four screws fixing the slot cover of the display by rotating
counterclockwise with a Phillips screwdriver. The removed screws are
used to fix the Interface Board.
f When removing the fourth screw, hold the slot cover with your hand so
it will not fall.
f To replace from other Interface Board, remove the Interface Board
following the procedure in "How to remove the Interface Board"
(x page 10).
2)
Install the Interface Board to the display device. (Fig. 2)
f Insert the guide groove of the Interface Board aligned to the salient of
the slot. Insert the bracket firmly all the way in.
3)
Fix the Interface Board. (Fig. 3)
f Tighten and fix with the four screws removed in Step 1).
Attention
f The removed slot cover is required when the unnecessary Interface Board is removed. Store
it so it can be attached in the future.
Installing the Interface Board
Salient
Guide groove
Fig. 2
Screws (4 locations)
Fig. 3
ENGLISH - 9
Advertisement
Table of Contents
