Table of Contents
Advertisement
How to install the Interface Board
Screws (4 locations)
Slot cover
Fig. 1
1)
Remove the slot cover. (Fig. 1)
f Remove the four screws fixing the slot cover of the projector by
rotating counterclockwise with a Phillips screwdriver. The removed
screws are used to fix the Interface Board.
f When removing the fourth screw, hold the slot cover with your hand so
it will not fall.
f To replace from other Interface Board, remove the Interface Board
following the procedure in "How to remove the Interface Board"
(x page 9).
2)
Install the Interface Board to the projector. (Fig. 2)
f Insert the guide groove of the Interface Board aligned to the salient of
the slot. Insert the bracket firmly all the way in.
3)
Fix the Interface Board. (Fig. 3)
f Tighten and fix with the four screws removed in Step 1).
Attention
f The removed slot cover is required when the unnecessary Interface Board is removed. Store
it so it can be attached in the future.
8 - ENGLISH
Installing the Interface Board
Guide groove
Fig. 2
Salient
Screws (4 locations)
Fig. 3
Advertisement
Table of Contents
